R60 USB to CAN Interface

The R60 USB to CAN interface is designed to connect the d&b Remote network (CAN-Bus) to a PC via USB (Universal Serial Bus) and must only be used within a d&b sound reinforcement system.

The R60 provides two RJ 45 CAN connectors with a built in switchable terminator and comes with drivers for Windows® operating systems. Up to five R60 interfaces may be connected to a PC and simultaneously operated by the R1 software.

Power supply

• Supply voltage: 5 V, powered via USB Bus
• Current drawn: < 100 mA
• Temperature range: 0 – 60 °C

Controls and indicators

• Termination: built in switchable terminator
• Termination of CAN-Bus with internal resistor: 120 / 1/4 W / ± 5%, with corresponding status LED
• Indicators (Status LEDs): ON, USB, CAN, ERROR, TERMINATE

Connectors

• USB: 1 x USB Type B connectors
• CAN: 2 x RJ 45 connectors, wired in parallel

Hardware

• Controller: 8 Bit
• Flash Memory Size: 32 k
• SRAM Size: 128 kB
• EEPROM Size: 2 kB
• Additional features: CAN galvanically isolated
• CAN Specification: 2.0 A/B
• CAN-Bus coupling: High Speed, according to ISO 11898
• Max. CAN Baud Rate: 1 Mbit/s

USB Specification

• USB Baud Interface: USB 1.1
• USB Buffer Memory: 256 messages
• PC Requirements: min. Pentium CPU, 32 MB RAM, 10 MB free disk space
• Supported Operating Systems: Windows® 2000, XP, Mac OSX®

Housing/Dimensions

• Housing: Extruded aluminium
• Dimensions (Height x width x depth): 125x85x35 mm [5″ x 3.5″ x 1.4″]
• Weight: 200 g (0.45 lb)